2 Cylinder Air Clamp/Vise

Clamp Operation and Maintenance Instructions

 Clamp Plates: Ensure the clamp plates are fully machined to guarantee an optimized clamping face.

Base and Plates: Use the 6" wide base with 6" clamping plates for enhanced mold stability and clamping surface 24 in long.

Pressure Requirements: Operate with a recommended pressure range of 100-140 psi.

Mold Centering individual culls: Ensure molds are centered to achieve optimal clamping pressure.

Post-Use: Remove air pressure from the clamp after each use.

Safety Warning: The clamp can pinch hands, fingers, or other body parts. The operator/owner assumes full responsibility for safe usage.

Cleaning: Clean the clamp with compressed air and WD-40 only.

Pressure Limits: Do not exceed 140 psi.

Lubrication: Lubricate the system with 3 drops of pneumatic tool oil per week of use. 

    Note: Frequent use may necessitate more frequent lubrication.

    Important: Use only pneumatic tool oil for lubrication.

Follow these instructions to ensure proper operation and maintenance of the clamp.

Shipping is usually 6 to 10 days. 

Clamp Operation and Maintenance Instructions

 Clamp Plates: Ensure the clamp plates are fully machined to guarantee an optimized clamping face.

Base and Plates: Use the 6" wide base with mold stability and clamping surface 24 in long. Clamp position is adjustable to dual machined patterns.

Pressure Requirements: Operate with a recommended pressure range of 100-140 psi.

Mold Centering individual culls: Ensure molds are centered to achieve optimal clamping pressure.

Post-Use: Remove air pressure from the clamp after each use.

Safety Warning: The clamp can pinch hands, fingers, or other body parts. The operator/owner assumes full responsibility for safe usage.

Cleaning: Clean the clamp with compressed air and WD-40 only.

Pressure Limits: Do not exceed 140 psi.

Lubrication: Lubricate the system with 3 drops of pneumatic tool oil per week of use. 

    Note: Frequent use may necessitate more frequent lubrication.

    Important: Use only pneumatic tool oil for lubrication.

Follow these instructions to ensure proper operation and maintenance of the clamp.

Shipping is usually 6 to 10 days out

 This kit allows you to upgrade your two-cylinder clamp to a four-cylinder clamp. It includes tubing, fittings, new end plates, and additional cylinders for enhanced clamping power. I will need your cylinder lengths as they did very in length over the years. Built to order.